Announcement

Collapse
No announcement yet.

Camber Kit - dimensions

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Camber Kit - dimensions










    photos in better quality
    http://speedy.sh/CMqnG/camber-kit.zip

    33321095102 - Eccentric bolt
    33326760668 - Self-locking collar nut
    33321092310/33306786186 - Eccentric flat washer

  • #2
    Please measure the thickness of the plates.

    Good reminder, just did a quick solidworks drawing. I'll countercheck the measurements when I got the right excentric bolts and create a .pdf file which will contain all nessecary measurements.

    Thanks for your pictures. Did you get the plates from e30-tech, too?

    Best regards,
    Phil

    Comment


    • #3
      plates got from a friend who bought it in the U.S.

      Comment


      • #4
        Before you fit these brackets, make sure that you get some geometry readings so that you know how to cut the holes in your existing trailing arm brackets, so that you can get the adjustable brackets located and welded in place to give you your optimum settings.

        The photo below shows the way that I have set up these brackets on my MC. The inner brackets adjust camber and the outer ones adjust toe.

        Last edited by exdos; 23-03-2012, 01:20 PM.
        /// Exdos ///
        "Men who try the impossible and fail spectacularly are infinitely superior to those who reach for nothing and succeed" --Napoleon Bonapart

        Comment


        • #5
          As promised, here is the .pdf. Have forgotten to countercheck the values...
          Anyway, here it is:
          http://www.xup.in/dl,77155076/HA_Exzenter.PDF/

          If there is anything wrong, tell me, I'll get it fixed.

          Best regards,
          Phil

          Comment

          Working...
          X