Apologies for bringing up an old thread, but was just wondering how you managed to change the bulb on your light that you sold...was it a hard job?
I've got a few light bulbs out and thought i'd have to get the whole light enclosure but if it's possible to just change the bulbs it could save me a few quid!
Apologies for bringing up an old thread, but was just wondering how you managed to change the bulb on your light that you sold...was it a hard job?
I've got a few light bulbs out and thought i'd have to get the whole light enclosure but if it's possible to just change the bulbs it could save me a few quid!
It was pretty easy but would be a lot easier with a solder sucker (which I don't have) worth a go as the new light assembly is expensive
Yes its held in by two spring clamps one either side. To remove push a flat head screwdriver( Bentley guide says use plastic pry tool) into slot at either end and this should free the complete light assembly.
what it doesn't show is the first step which is to use a flat head screwdriver or thin plastic pry tool inserted in either end of the lamp to free one end at a time.
Comment