Dear all
As you may know from my thread I've been sorting out my rust issue, and as part of this fitted new OEM sill covers and front wing panels, which raised 2 noob questions.
1. On the Sill trim, do you adjust it side to side based on the gap it leaves to the 1/4 panel, or to the furthest point forward or back as it rocks on the fixing bolt if that makes sense?
2. When fixing the OEM wing, I can not get the edge to be flush with the door, the door is in the correct place.
The only way I can see is to bend the wing mount bracket on the body to be flatter?
Is there a trick I'm missing?
This tab is quite rigid, and can not move much more to make the difference.
cheers in advance
John
As you may know from my thread I've been sorting out my rust issue, and as part of this fitted new OEM sill covers and front wing panels, which raised 2 noob questions.
1. On the Sill trim, do you adjust it side to side based on the gap it leaves to the 1/4 panel, or to the furthest point forward or back as it rocks on the fixing bolt if that makes sense?
2. When fixing the OEM wing, I can not get the edge to be flush with the door, the door is in the correct place.
The only way I can see is to bend the wing mount bracket on the body to be flatter?
Is there a trick I'm missing?
This tab is quite rigid, and can not move much more to make the difference.
cheers in advance
John
Comment