I think I may have seen these before and what stopped me was the lack of holes for the pegs to go through.
I'm considering getting some with a piped edge to match the LSB interior but worried it might chav it up a bit.
I replaced mine 2 years ago with aftermarket mats and they did not have the holes. I put the old mats over the new, marked the hole positions, then cut small holes in the new ones. The old mat plastic retaining circles pull apart above and below the mat and it was a very simple job to put them into the new ones. Job done.
Strongstrut CL front brace-Yellowstuff pads/Castrol SRF race brake fluid-Rogue top mounts/Rear support bushes-H&R ARBs-Whiteline droplinks-Bilstein Sport shockers-H&R Springs-Black Halo Angel Eye headlight units-Sachs lightweight flywheel/matching clutch-Supersprint exhaust/race catalysers-BBS RSGTs with Falkens-K&N High Flow Air Filter-Recaro Pole Position seats - Exdos mod - ACS flippers
I got some new bmw mats from the dealers, but they only listed them for s54. They didn't have the hard plastic 'twist' fittings but velcro instead.
All i did was take the removable fittings off the old mats and put them on the new ones after carefully making a circular hole for them.........Job done!
Comment