Bit more progress made today
Got it off the trailer and next to the garage to make it easier to work on and saves running extension leads all over to run the grinder.
It also got treated to a new bonnet badge from Adz S when he called in to have a look
Mi bro’s coupe tucked away in the garage
Then got on with finishing off removing the black rubbish off the boot floor to see how bad the floor is.
Before
After, doesn’t look as bad now it’s clean
Next job was to remove the diff and get a look at the underside, this looks a bit worse but nothing that can’t be fixed
Tomorrow’s job is to cut out the box section and boot floor
The channel / box section is being cut out from just inside the anti roll bar mounts (these are coming off as well to allow some strengthening plates to be fitted).
The floor is being removed to the edge of the lip on the channel on the underside and the full width of the floor to the raised sections at each side.
Got it off the trailer and next to the garage to make it easier to work on and saves running extension leads all over to run the grinder.
It also got treated to a new bonnet badge from Adz S when he called in to have a look
Mi bro’s coupe tucked away in the garage
Then got on with finishing off removing the black rubbish off the boot floor to see how bad the floor is.
Before
After, doesn’t look as bad now it’s clean
Next job was to remove the diff and get a look at the underside, this looks a bit worse but nothing that can’t be fixed
Tomorrow’s job is to cut out the box section and boot floor
The channel / box section is being cut out from just inside the anti roll bar mounts (these are coming off as well to allow some strengthening plates to be fitted).
The floor is being removed to the edge of the lip on the channel on the underside and the full width of the floor to the raised sections at each side.
Comment