Announcement

Collapse
No announcement yet.

Panel Gap Advise - Z3M

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I am not sure why bolting in your liners have moved things, but if you take them back out there is some adjustment at the top rear bumper mounting points. Certainly enough to even up the gap shown on your photo.
    Have a careful look when removing liners to see what has happened, it could be that the fixing bolt on the points I mentioned are just not tightened down enough.

    Howard

    Comment


    • #17
      Thanks for your input. The bolts were 100% fine, I redid them in any event before posting on the forum, just in case.

      I'm embarrassed to say that it was all my own fault, it came to me when I had 5 mins off today that It must have been the zip ties I used to stop the back of the engine cover moving around, I had clipped them up when there were no liners.

      I undid them, and then the bumper came back down.



      The fixing up of the liner at the front caused the bumper to tighten up against the antiroll bar, to which I used the cable ties, and thus rotated round.

      It's all good now, just one fo those daft things.

      cheers J.
      Last edited by Jonnysideways; 10-04-2020, 11:08 PM.
      2001 E46 M3 Coupe for me / 2007 E91 335i for the Dogs.

      Comment

      Working...
      X