Announcement

Collapse
No announcement yet.

Driver seat wiring after refit - airbag light on.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Driver seat wiring after refit - airbag light on.

    Folks

    I took the drivers seat out to clean the carpets and repair a couple of bits.

    I put it back in and thought I connected everything up - turns out I didn’t as the airbag light is on now 😩

    Does anyone have a photo or diagram with the wiring shown to ensure I haven’t missed anything obvious.
    I did reroute a couple of wires as they would potentially get caught when I move the seat but that’s it.

    Thanks
    R

  • #2
    Hey Rags, there's a revised supplementary harness that some (myself included) have fitted to sort this recurring problem once and for all, if you find that you have already connected everything correctly but you still have the issue
    Not actually in the least bit fat

    2000 S50 Titanium Silver / Black
    ACS Suspension, Exhaust & Type III Wheels
    Simota carbon air intake | Strong Strut Front Brace

    Comment


    • #3
      Unless you disconnected the battery before removing the seat/disconnecting the airbag connector, the airbag light will come on and need a reset.

      Comment


      • #4
        Drivers side wiring pictures, check the pre-tensioner is seated properly as the cable tie can become loose.






        Comment


        • #5
          Thanks guys, will check out the cable tie as I didn’t actually afix that back doh

          Comment

          Working...
          X